Genie GS-1530 Service And Repair Manual page 148

Service and Repair Manual
Scissor Components
20 Install new cylinder, fittings, hoses and
pressure transducer (if equipped).
Torque specifications
Solenoid valve, 2 position 2 way,
N.C.
(schematic item N)
Coil nut
Pressure transducer(if equipped)
(schematic item R)
21 Remove the lifting device supporting the link
stack at the steer end of the machine.
22 Connect the battery pack to the machine.
23 Turn the key switch to ground control.
Models without a pressure transducer
continue at step 27.
Models with a pressure transducer
continue at step 24.
24 Press and hold the ground control scroll up
and scroll down buttons.
25 Pull out the red Emergency Stop button to the
on position at the ground controls.
26 Using the ground control menu buttons,
navigate to Service Override Mode. Select
Service Override Mode.
Note: The machine must be in Service Override
Mode to raise the platform. While in Service
Override Mode, only the GCON will operate with
limited functionality. The platform will raise a
predetermined amount of time and stop.
27 Raise the platform and rotate the safety arm to
the stowed position.
28 Fully lower the platform to the stowed position.
Note: Models with a pressure transducer, calibrate
the Platform Overload System. Refer to Repair
Procedure, How to Calibrate the Platform Overload
System (if equipped).
132
GS-2032, GS-2632, GS-2046 and GS-2646
20 ft-lbs
27 Nm
5 ft-lbs
7 Nm
27 ft-lbs
37 Nm
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
Note: Models without a pressure transducer follow
steps 1 through 23, 27 and 28.
Models equipped with a pressure transducer follow
steps 1 through 28.
1
2
GS-30 • GS-32 • GS-46 • GS-47
Bodily injury hazard. The
procedures in this section
require specific repair skills,
lifting equipment and a suitable
workshop. Attempting this
procedure without these skills
and tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Turn the key switch to ground controls and pull
out the red Emergency Stop button to the on
position at both ground and platform controls.
Raise the platform 7 to 8 feet / 2.1 to 2.4 m.
September 2016
Part No. 1272217