Genie GS-1530 Service And Repair Manual page 118

Service and Repair Manual
Scissor Components
16 Install the fasteners removed in 14 to the
number 1 inner arm pivot bracket and chassis.
Tip-over hazard. Failure
to install the fasteners securing
the number 1 inner arm pivot
bracket to the chassis, could
result in the machine tipping
over, causing death or serious
injury.
17 Connect the battery pack to the machine.
18 Turn the key switch to ground controls.
19 Press and hold the ground control scroll up
and scroll down buttons.
20 Pull out the red Emergency Stop button to the
on position at the ground controls.
21 Using the ground control menu buttons,
navigate to Service Override Mode. Select
Service Override Mode.
Note: The machine must be in Service Override
Mode to raise the platform. While in Service
Override Mode, only the GCON will operate with
limited functionality. The platform will raise a
predetermined amount of time and stop.
22 Raise the platform and rotate the safety arm to
the stowed position.
102
23 Fully lower the platform to the stowed position.
GS-30 • GS-32 • GS-46 • GS-47
Cable bridge and platform height sensor
1 cable bridge 4
2 cable bridge 3A
3 cable bridge 3B
4 cable bridge 2A
5 cable bridge 2B
6 cable bridge 1
7 platform height sensor
September 2016
Part No. 1272217