Genie GS-1530 Service And Repair Manual page 106

Service and Repair Manual
Scissor Components
55 Remove the number 2 cable bridge mounting
fasteners and remove the cable bridge from
the machine.
56 Attach a lifting strap from an overhead crane
to the number 2 outer arm (index #19) at the
ground controls side.
57 Use a soft metal drift to remove the number
2 center pivot pin (index #7) at the ground
controls side.
58 Remove the retaining fasteners from the
number 2 pivot pin (index #20) at the
non-steer end of the machine.
59 Use a soft metal drift to tap the number 2 pivot
pin (index #20) halfway out at the non-steer
end of the machine. Remove the number
2 outer arm (index #19) from the ground
controls side of the machine.
Bodily injury hazard. The number
2 outer arm at the ground
controls side may become
unbalanced and fall if not
properly supported when
removed from the machine.
60 Attach a lifting strap from an overhead crane
to the number 2 outer arm (index #19) at the
battery pack side.
61 Remove the external snap rings and retaining
fasteners from the number 2 center pivot pin
(index #7) at the battery pack side.
62 Use a soft metal drift to remove the number
2 center pivot pin (index #7) at the battery
pack side.
Bodily injury hazard. The number
2 outer arm at the battery pack
side may become unbalanced
and fall if not properly supported
when removed from the
machine.
90
63 Use a soft metal drift to tap the number 2 pivot
64 Remove the number 3 pivot pin (index #17)
65 Attach a lifting strap from an overhead crane
66 Remove the retaining fasteners from the
67 Use a soft metal drift to remove the number
68 Remove the safety arm from the number
69 Attach a lifting strap from an overhead crane
GS-30 • GS-32 • GS-46 • GS-47
pin (index #20) in the other direction at the
non-steer end. Remove the number 2 outer
arm (index #19) from the battery pack side of
the machine.
Bodily injury hazard. The number
2 outer arm at the battery pack
side may become unbalanced
and fall if not properly supported
when removed from the
machine.
from the non-steer end of the machine.
to the number 2 inner arm (index #18).
number 2 pivot pin (index #8) at the steer end
of the machine.
2 pivot pin (index #8). Remove the number
2 inner arm (index #18) from the machine.
Bodily injury hazard. The number
2 inner arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
2 inner arm (index #18) that was just removed.
to the number 1 inner arm (index #10).
September 2016
Part No. 1272217