Genie GS-1530 Service And Repair Manual page 135

September 2016
13 Remove the squeeze connector from the large
platform height sensor bracket.
14 Remove the fasteners securing the large
platform height sensor bracket to the number
1 inner arm pivot bracket.
15 Remove the large platform height sensor
bracket from the number 1 inner arm pivot
bracket.
16 Install the fasteners removed in 14 to the
number 1 inner arm pivot bracket and chassis.
Tip-over hazard. Failure
to install the fasteners securing
the number 1 inner arm pivot
bracket to the chassis, could
result in the machine tipping
over, causing death or serious
injury.
17 Connect the battery pack to the machine.
18 Turn the key switch to ground controls.
19 Press and hold the ground control scroll up
and scroll down buttons.
20 Pull out the red Emergency Stop button to the
on position at the ground controls.
21 Using the ground control menu buttons,
navigate to Service Override Mode. Select
Service Override Mode.
Note: The machine must be in Service Override
Mode to raise the platform. While in Service
Override Mode, only the GCON will operate with
limited functionality. The platform will raise a
predetermined amount of time and stop.
22 Raise the platform and rotate the safety arm to
the stowed position.
Part No. 1272217
23 Fully lower the platform to the stowed position.
GS-30 • GS-32 • GS-46 • GS-47
Service and Repair Manual
Scissor Components
Cable bridge and platform height sensor
1 cable bridge 6
2 cable bridge 5B
3 cable bridge 5A
4 cable bridge 4B
5 cable bridge 4A
6 cable bridge 1A
7 platform height sensor
8 cable bridge 1B
9 cable bridge 2A
10 cable bridge 2B
11 cable bridge 2C
12 cable bridge 2D
119