Genie GS-1530 Service And Repair Manual page 132

Service and Repair Manual
Scissor Components
106 Models with platform overload option: Tag
and disconnect the wire harness from the
platform overload pressure transducer.
Note: After replacing the scissor assembly, the
platform overload system must be calibrated.
Refer to Repair Procedure, How to Calibrate the
Platform Overload System (if equipped).
107 Raise the lift cylinder to a vertical position.
108 Remove the pin retaining fasteners from the
lift cylinder barrel-end pin (index #28). Use a
soft metal drift to remove the pin. Remove the
lift cylinder from the machine.
Crushing hazard. The lift cylinder
will fall if not properly supported
when the pivot pin is removed.
Component damage hazard. Be
careful not to damage the valve
or fittings on the cylinder while
removing it from the machine.
109 Remove the cables from the number 1 cable
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
110 Disconnect the number 1 cable bridge from
the number 1 outer arm (index #29) and
remove the cable bridge from the machine.
111 Attach a lifting strap from an overhead crane
to the number 1 inner arm (index #14).
112 Raise the arm slightly and remove the block.
116
113 Lower the arm to the stowed position.
114 Secure the ends of the scissor arms together
115 Secure the ends of the scissor arms together
116 Remove the retaining fasteners securing the
117 Remove the linkset from the machine.
GS-30 • GS-32 • GS-46 • GS-47
Bodily injury hazard. Keep hands
clear of moving parts when
lowering the scissor arms.
at the steer end of the machine with a strap or
other suitable device.
at the non-steer end of the machine with a
strap or other suitable device.
chassis mount bracket to the chassis.
Bodily injury hazard. The number
1 inner and outer arms (index
#14 and #29) may become
unbalanced and fall if not
properly supported when
removed from the machine.
Component damage hazard. Be
sure not to damage the limit
switch or level sensor
components when the number
1 inner and outer arms (index
#14 and #29) are removed from
the machine.
September 2016
Part No. 1272217