Genie GS-1530 Service And Repair Manual page 129

September 2016
58 Place a rod through the number 4 center pivot
pin at the battery side (index #5) and twist to
remove the pin.
59 Remove the number 4 outer arm (index #20)
from the machine.
Crushing hazard. The number
4 outer arm (index #20) may
become unbalanced and fall if
not properly supported when
removed from the machine.
60 Attach a lifting strap from an overhead crane
to the number 4 inner arm (index #19). Raise
the arm to a vertical position.
61 Remove the retaining fasteners from the
number 4 pivot pin at the steer end of the
machine (index #6).
62 Use a soft metal drift to remove the number
4 pivot pin (index #6) from the steer end of the
machine. Remove the number 4 inner arm
(index #19) from the machine.
Crushing hazard. The number
4 inner arm (index #19) may
become unbalanced and fall if
not properly supported when
removed from the machine.
63 Remove the cables from the number 3A and
3B cable bridges and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
64 Disconnect the number 3A and 3B cable
bridges from the scissor linkset and remove
both cable bridges from the machine.
65 Attach a lifting strap from an overhead crane
to the number 3 outer arm at the ground
control side (index #7).
Part No. 1272217
66 Remove the retaining fasteners from the
67 Place a rod through the number 3 center pivot
68 Remove the retaining fasteners from the
69 Use a soft metal drift to remove the number
70 Attach a lifting strap from an overhead crane
71 Remove the retaining fasteners from the
72 Place a rod through the number 3 center pivot
73 Remove the number 3 outer arm (index #7)
GS-30 • GS-32 • GS-46 • GS-47
Service and Repair Manual
Scissor Components
number 3 center pivot pin (index #8) at the
ground control side.
pin at the ground control side (index #8) and
twist to remove the pin.
number 3 pivot pin (index #24) at the
non-steer end.
3 pivot pin (index #24) from the non-steer end
of the machine. Remove the number 3 outer
arm at the ground control side (index #7) from
the machine.
Crushing hazard. The number
3 outer arm at the ground control
side (index #7) may become
unbalanced and fall if not
properly supported when
removed from the machine.
to the number 3 outer arm at the battery side
(index #7).
number 3 center pivot pin (index #8) at the
battery side.
pin at the battery side (index #8) and twist to
remove the pin.
from the machine.
Crushing hazard. The number
3 outer arm (index #7) may
become unbalanced and fall if
not properly supported when
removed from the machine.
113