Genie GS-1530 Service And Repair Manual page 127

September 2016
24 Remove the platform. Refer to Repair
Procedure, How to Remove the Platform.
25 Support and secure the entry ladder to an
appropriate lifting device.
26 Remove the fasteners from the entry ladder
and remove the entry ladder from the
machine.
Crushing hazard. The entry
ladder will fall if not properly
supported and secured to the
lifting device.
27 Remove the cables from the number 5 cable
bridge and lay them off to the side.
28 Disconnect the number 4 cable bridge from
the number 5 outer arm (index #17) and
remove the cable bridge from the machine.
29 Remove the retaining fasteners from the
number 6 pivot pin (index #1).
30 Use a soft metal drift to remove the number
6 pivot pin (index #1). Remove the platform
mount bracket from the machine.
31 Attach a lifting strap from an overhead crane
to the number 5 outer arm at the ground
control side (index #17).
32 Remove the retaining fasteners from the
number 5 center pivot pin (index #2) at the
ground control side.
33 Place a rod through the number 5 center pivot
pin at the ground control side (index #2) and
twist to remove the pin.
34 Remove the retaining fasteners from the
number 5 pivot pin (index #18) at the
non-steer end.
Part No. 1272217
35 Use a soft metal drift to remove the number
36 Attach a lifting strap from an overhead crane
37 Remove the retaining fasteners from the
38 Place a rod through the number 5 center pivot
39 Remove the number 5 outer arm (index #17)
40 Attach a lifting strap from an overhead crane
41 Remove the retaining fasteners from the
GS-30 • GS-32 • GS-46 • GS-47
Service and Repair Manual
Scissor Components
5 pivot pin (index #18) from the non-steer end
of the machine. Remove the number 5 outer
arm at the ground control side (index #17)
from the machine.
Crushing hazard. The number
5 outer arm at the ground control
side (index #17) may become
unbalanced and fall if not
properly supported when
removed from the machine.
to the number 5 outer arm at the battery side
(index #17).
number 5 center pivot pin (index #2) at the
battery side.
pin at the battery side (index #2) and twist to
remove the pin.
from the machine.
Crushing hazard. The number
5 outer arm (index #17) may
become unbalanced and fall if
not properly supported when
removed from the machine.
to the number 5 inner arm (index #16). Raise
the arm to a vertical position.
number 5 pivot pin at the steer end of the
machine (index #4).
111