Genie GS-1530 Service And Repair Manual page 120

Service and Repair Manual
Scissor Components
41 Remove the retaining fasteners from the
number 4 pivot pin at the steer end of the
machine (index #3).
42 Use a soft metal drift to remove the number
4 pivot pin (index #3) from the steer end of the
machine. Remove the number 4 inner arm
(index #12) from the machine.
Crushing hazard. The number
4 inner arm (index #12) may
become unbalanced and fall if
not properly supported when
removed from the machine.
43 Remove the cables from the number 3A and
3B cable bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
44 Disconnect the number 3A and 3B cable
bridges from the scissor linkset and remove
both cable bridges from the machine.
45 Attach a lifting strap from an overhead crane
to the number 3 outer arm at the ground
control side (index #16).
46 Remove the retaining fasteners from the
number 3 center pivot pin (index #4) at the
ground control side.
47 Place a rod through the number 3 center pivot
pin at the ground control side (index #4) and
twist to remove the pin.
48 Remove the retaining fasteners from the
number 3 pivot pin (index #17) at the
non-steer end.
104
49 Use a soft metal drift to remove the number
50 Attach a lifting strap from an overhead crane
51 Remove the retaining fasteners from the
52 Place a rod through the number 3 center pivot
53 Remove the number 3 outer arm (index #16)
54 Attach a lifting strap from an overhead crane
55 Remove the retaining fasteners from the lift
GS-30 • GS-32 • GS-46 • GS-47
3 pivot pin (index #17) from the non-steer end
of the machine. Remove the number 3 outer
arm at the ground control side (index #16)
from the machine.
Crushing hazard. The number
3 outer arm at the ground control
side (index #16) may become
unbalanced and fall if not
properly supported when
removed from the machine.
to the number 3 outer arm at the battery side
(index #16).
number 3 center pivot pin (index #4) at the
battery side.
pin at the battery side (index #4) and twist to
remove the pin.
from the machine.
Crushing hazard. The number
3 outer arm (index #16) may
become unbalanced and fall if
not properly supported when
removed from the machine.
to the lug of the rod end of the lift cylinder.
cylinder rod end pivot pin (index #5).
September 2016
Part No. 1272217