Genie GS-1530 Service And Repair Manual page 130

Service and Repair Manual
Scissor Components
74 Attach a lifting strap from an overhead crane
to the lug of the rod end of the upper lift
cylinder.
75 Raise the lift cylinder to a vertical position.
76 Remove the pin retaining fasteners from the
lift cylinder barrel-end pivot pin (index #22).
Remove the lift cylinder from the machine.
Crushing hazard. The lift cylinder
will fall if not properly supported
when the pivot pin is removed.
Component damage hazard. Be
careful not to damage the valve
or fittings on the cylinder while
removing it from the machine.
77 Attach a lifting strap from an overhead crane
to the lug of the rod end of the lower lift
cylinder.
78 Remove the retaining fasteners from the lower
lift cylinder rod end pivot pin (index #9).
79 Use a soft metal drift to remove the lower lift
cylinder rod end pivot pin (index #9) from the
machine.
Crushing hazard. The lift cylinder
will fall if not properly supported
when the pivot pin is removed.
80 Place a 4 x 4 x 10 inch / 10 x 10 x 25 cm block
onto the number 1 inner arm cylinder plate
(index #14).
81 Lower the cylinder onto the block.
Bodily injury hazard. Keep hands
clear of moving parts when
lowering the cylinder.
82 Attach a lifting strap from an overhead crane
to the number 3 inner arm (index #23). Raise
the arm to a vertical position.
114
83 Remove the retaining fasteners from the
84 Use a soft metal drift to remove the number
85 Remove the cables from the number 2A and
86 Disconnect the number 2A and 2B cable
87 Attach a lifting strap from an overhead crane
88 Remove the retaining fasteners from the
89 Place a rod through the number 2 center pivot
90 Remove the retaining fasteners from the
GS-30 • GS-32 • GS-46 • GS-47
number 3 pivot pin at the steer end of the
machine (index #10).
3 pivot pin (index #10) from the steer end of
the machine. Remove the number 3 inner arm
(index #23) from the machine.
Crushing hazard. The number
3 inner arm (index #23) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
2B cable bridges and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
bridges from the scissor linkset and remove
both cable bridges from the machine.
to the number 2 outer arm at the ground
control side (index #26).
number 2 center pivot pin (index #11) at the
ground control side.
pin at the ground control side (index #11) and
twist to remove the pin.
number 2 pivot pin (index #27) at the
non-steer end.
September 2016
Part No. 1272217