Genie GS-1530 Service And Repair Manual page 105

September 2016
42 Use a soft metal drift to tap the number 3 pivot
pin (index #17) halfway out at the non-steer
end of the machine. Remove the number
3 outer arm (index #16) at the ground controls
side from the machine.
Bodily injury hazard. The number
3 outer arm at the ground
controls side may become
unbalanced and fall if not
properly supported when
removed from the machine.
43 Attach a lifting strap from an overhead crane
to the number 3 outer arm (index #16) at the
battery pack side.
44 Use a soft metal drift to remove the number
3 center pivot pin (index #4) at the battery
pack side of the machine.
45 Use a soft metal drift to tap the number 3 pivot
pin (index #17) in the other direction. Remove
the number 3 outer arm (index #16) from the
battery pack side of the machine.
Bodily injury hazard. The number
3 outer arm at the battery pack
side may become unbalanced
and fall if not properly supported
when removed from the
machine.
46 Remove the number 3 pivot pin (index #17)
from the non-steer end of the machine.
47 Attach a lifting strap from an overhead crane
to the lug on the rod end of the lift cylinder for
support. Do not apply any lifting pressure.
Part No. 1272217
48 Remove the pin retaining fasteners from the
49 Lower the cylinder onto the number 1 inner
50 Attach a lifting strap from an overhead crane
51 Remove the retaining fasteners from the
52 Use a soft metal drift to remove the number
53 Remove the cables from the number 2 cable
54 Remove the external snap rings and retaining
GS-30 • GS-32 • GS-46 • GS-47
Service and Repair Manual
Scissor Components
lift cylinder rod-end pivot pin (index #5). Use a
soft metal drift to remove the pin.
Bodily injury hazard. The
cylinder may fall when the
rod-end pivot pin is removed if
not properly supported.
arm (index #9).
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
to the number 3 inner arm (index #15).
number 3 pivot pin (index #6) at the steer end.
3 pivot pin (index #6). Remove the number
3 inner arm (index #15) from the machine.
Bodily injury hazard. The number
3 inner arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
fasteners from the number 2 center pivot pin
(index #7) at the ground controls side.
89