Genie GS-1530 Service And Repair Manual page 122

Service and Repair Manual
Scissor Components
71 Place a rod through the number 2 center pivot
pin at the battery side (index #7) and twist to
remove the pin.
Crushing hazard. The number
2 outer arm (index #19) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
72 Remove the number 2 outer arm (index #19)
from the machine.
Crushing hazard. The number
2 outer arm (index #19) may
become unbalanced and fall if
not properly supported when
removed from the machine.
73 Attach a lifting strap from an overhead crane
to the number 2 inner arm (index #18). Raise
the arm to a vertical position.
74 Remove the retaining fasteners from the
number 2 pivot pin at the steer end of the
machine (index #8).
75 Use a soft metal drift to remove the number
2 pivot pin (index #8) from the steer end of the
machine. Remove the number 2 inner arm
(index #18) from the machine.
Crushing hazard. The number
2 inner arm (index #18) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
76 Attach a lifting strap from an overhead crane
to the number 1 inner arm (index #10).
77 Raise the number 1 inner arm (index #10)
approximately 2 feet / 60 cm.
106
78 Place a 4 x 4 x 48 inch / 10 cm x 10 cm x
79 Lower the scissor arms onto the block that
80 Attach a lifting strap from an overhead crane
81 Tag, disconnect and plug the hydraulic hose
82 Tag and disconnect the wire harness from the
83 Tag and disconnect the wires and manual
84 Models with platform overload option: Tag
Note: After replacing the scissor assembly, the
platform overload system must be calibrated.
Refer to Repair Procedure, How to Calibrate the
Platform Overload System (if equipped).
GS-30 • GS-32 • GS-46 • GS-47
1.2 m long block across both sides of the
chassis under the number 1 center pivot pin
(index #9).
was placed across the chassis.
Bodily injury hazard. Keep hands
clear of moving parts when
lowering the scissor arms.
to the lug of the rod end of the lower lift
cylinder.
on the lower lift cylinder. Cap the fittings on the
cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
solenoid valve on the cylinder.
lowering cable from the solenoid valve on the
cylinder.
and disconnect the wire harness from the
platform overload pressure transducer.
September 2016
Part No. 1272217