Genie GS-1530 Service And Repair Manual page 100

Service and Repair Manual
Scissor Components
62 Place a 4 x 4 x 48 inch / 10 cm x 10 cm x
1.2 m long block across both sides of the
chassis under the number 1 center pivot pin
(index #7).
63 Attach a lifting strap from an overhead crane
to the number 1 inner arm (index #8) at the
non-steer end. Raise the number 1 inner arm
and remove the safety arm. Lower the number
1 inner arm (index #8) onto the block that was
placed across the chassis.
Bodily injury hazard. Keep hands
clear of moving parts when
lowering the scissor arms.
64 Remove the cables from the number 1 cable
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
65 Support and secure the entry ladder to an
appropriate lifting device.
66 Remove the fasteners from the entry ladder
and remove the entry ladder from the
machine.
Crushing hazard. The entry
ladder will fall if not properly
supported and secured to the
lifting device.
67 Attach a lifting strap from an overhead crane
to the number 1 outer arm (index #17). Do not
apply any lifting pressure.
68 Remove the external snap rings and retaining
fasteners from the number 1 center pivot pins
(index #7).
69 Remove the number 1 cable bridge from the
machine.
84
70 Use a soft metal drift to remove the number
71 Slide the number 1 outer arm (index #17) to
72 Attach the strap from an overhead crane to the
73 Remove the upper fasteners securing the
74 Remove the number 1 inner arm (index #8)
GS-30 • GS-32 • GS-46 • GS-47
1 center pivot pins (index #7).
Bodily injury hazard. The number
1 outer arm may become
unbalanced and fall if not
properly supported when the pin
is removed.
the non-steer end and remove it from the
machine.
Bodily injury hazard. The number
1 outer arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
number 1 inner arm (index #8). Do not lift it.
number 1 inner arm pivot bracket to the end of
the chassis. Loosen the lower fasteners.
from the machine.
Bodily injury hazard. The number
1 inner arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
Component damage hazard. Be
sure not to damage the limit
switch or level sensor
components when the number
1 inner arm is removed from the
machine.
September 2016
Part No. 1272217