Genie GS-1530 Service And Repair Manual page 137

September 2016
42 Remove the retaining fasteners from the
number 5 center pivot pin (index #4) at the
ground control side.
43 Place a rod through the number 5 center pivot
pin at the ground control side (index #4) and
twist to remove the pin.
44 Remove the retaining fasteners from the
number 5 pivot pin (index #23) at the
non-steer end.
45 Use a soft metal drift to remove the number
5 pivot pin (index #23) from the non-steer end
of the machine. Remove the number 5 outer
arm at the ground control side (index #22)
from the machine.
Crushing hazard. The number
5 outer arm at the ground control
side (index #22) may become
unbalanced and fall if not
properly supported when
removed from the machine.
46 Attach a lifting strap from an overhead crane
to the number 5 outer arm at the battery side
(index #22).
47 Remove the number 5 outer arm (index #22)
from the machine.
Crushing hazard. The number
5 outer arm at the battery side
(index #22) may become
unbalanced and fall if not
properly supported when
removed from the machine.
48 Tag and disconnect the wire harness from the
solenoid valve on the cylinder.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
Part No. 1272217
49 Attach a lifting strap from an overhead crane
50 Remove the retaining fasteners from the
51 Use a soft metal drift to remove the upper lift
52 Lower the cylinder onto the linkset.
53 Attach a lifting strap from an overhead crane
54 Remove the retaining fasteners from the
55 Place a rod through the number 4 center pivot
56 Remove the retaining fasteners from the
57 Use a soft metal drift to remove the number
GS-30 • GS-32 • GS-46 • GS-47
Service and Repair Manual
Scissor Components
to the lug of the rod end of the upper lift
cylinder.
upper lift cylinder rod end pivot pin (index #5).
cylinder rod end pivot pin (index #5) from the
machine.
Crushing hazard. The lift cylinder
will fall if not properly supported
when the pivot pin is removed.
to the number 4 outer arm at the ground
control side (index #25).
number 4 center pivot pin (index #7) at the
ground control side.
pin at the ground control side (index #7) and
twist to remove the pin.
number 4 pivot pin (index #26) at the
non-steer end.
4 pivot pin (index #26) from the non-steer end
of the machine. Remove the number 4 outer
arm at the ground control side (index #25)
from the machine.
Crushing hazard. The number
4 outer arm at the ground control
side (index #25) may become
unbalanced and fall if not
properly supported when
removed from the machine.
121