R O L A N D
Rev. 1.0
Available configuration modes:
•
Configuration system parameter
•
Configuration program parameter
•
Data backup (not for B version units)
System parameters are general adjustments (e.g. language).
Program parameters are specific adjustments, depending on the application (e.g. input of nominal
thickness).
Note: After leaving the configuration mode the password remains active for five
minutes. Thus other configuration adjustments can be made, without re-entering the
password. If no keys are pressed while in the menu level than the program changes
into the measurement mode.
7.6 System parameters
Note: The selected system configuration should be documented in the form
"System configuration" in chapter 11."Technical data" or in the equipment
documentation. This information is required in case a system becomes exchanged.
The general adjustments are specified by the configuration of system parameters.
For this purpose the system parameter configuration mode must be selected and confirmed with ENTER .
Then the following menu item appears:
System parameter 1: setting the dialog language.
System parameter 2: specifying the type of sensor.
Note: Currently only the type of sensor PW42A is selectable.
ROLAND ELECTRONIC GMBH · Otto-Maurer-Str. 17 · D-75210 Keltern · Telefon (0049) (07236) 9392-0 · Telefax (0049) (07236) 9392-33
OPERATING INSTRUCTIONS
DOUBLE SHEET DETECTOR R1000 UDK20
System param.: 1
language:english
System param.: 2
sensor type:PW42
Picture: Seltting the dialog language
Picture: Specifying the type of sensor
Page 77