Table of Contents
Advertisement
R O L A N D
Page 88
Then the following message appears:
This measured value can be accepted or changed, for example to calibrate the control unit.
After the teach-in has been completed the following message appears:
Attention!
For sequence 1+2 the teach-in is separately performed for sensor 1 and 2.
Entering the information for the selected measuring program is now completed.
ROLAND ELECTRONIC GMBH · Otto-Maurer-Str. 17 · D-75210 Keltern · Telefon (0049) (07236) 9392-0 · Telefax (0049) (07236) 9392-33
OPERATING INSTRUCTIONS
DOUBLE SHEET DETECTOR R1000 UDK20
Program Par.:
System Param.:12
P12 LW:24-32mS/m
TI-value: 0.97mm
Program Par.:
System Param.:12
P12 LW:24-32mS/m
teach-in: ok
8
Picture: Teach-in measurement value
8
Picture: Teach-in successfully completed
B0048991
Advertisement
Table of Contents
