ROLAND
Page 96
9.1 Fault messages of the Sensor Switch Box
If the Sensor Switch Box was configured though none is attached to the system, then the system emits
a fault message. In order to reconfigure the equipment to the correct adjustment "no Sensor Switch Box",
the unit must be switched off and on.
The following message is displayed:
After pressing the MENU key the following message is displayed:
Adjustment for operating the Sensor Switch Box:
•
yes: The equipment should continue operating with a Sensor Switch Box. The fault is cleared. If the
fault condition is not eliminated, then the fault message appears again.
•
no = CLR Param.: The equipment has to be reconfigured to operate without a Sensor Switch Box.
All program parameters are deleted.
Attention: The deletion of the programs parameter cannot be undone.
The arrow keys allow the change between "yes" and "no". Confirm the selection with the ENTER key.
ROLAND ELECTRONIC GMBH · Otto-Maurer-Str. 17 · D-75210 Keltern · Telefon (0049) (07236) 9392-0 · Telefax (0049) (07236) 9392-33
OPERATING INSTRUCTIONS
DOUBLE SHEET DETECTOR R1000 UDK20
no switchbox
System Param.:12
P12 LW:24-32mS/m
or defective
UDK20+switchbox?
System Param.:12
P12 LW:24-32mS/m
Picture: System does not recognize a Sensor Switch Box
yes
Picture: Selection, if the Switch Box is to be operated
B0048991