Table of Contents
Advertisement
ROLAND
Page 36
4.3.1 Spring loaded sensor bracket SHS42G-FB (with bellow suction cup)
The spring loaded sensor bracket SHS42G-FB with bellow suction cup is intended for the installation of
the PW sensor. It is well suitable for for use in robotic destackers, since transversal forces (appearing
on fast turning motions) are well compensated.
The suction vacuum and the integrated nap ring assure a full-area pressure contact of sensor and
sheet.
The suction cup has a Shore hardness of 45 (red), suction cups with a Shore hardness of 60 (black)
are available as spare part ( see chapter 12 „Order data - sensors and accessories).
On installing, attention must be paid that the sensor is thoroughly sealed (e.g. with Teflon tape) in the
thread seating.
Considerations:
•
The sensor face must align with the naps.
•
The vacuum must adequately effect.
•
The suction facility must be kept free from loading, i.e. the springs may only be low pre-tensioned.
•
The suction facility must not be used as load-lifting device.
60,5
39,5
( 1 : 2 )
ROLAND ELECTRONIC GMBH · Otto-Maurer-Str. 17 · D-75210 Keltern · Telefon (0049) (07236) 9392-0 · Telefax (0049) (07236) 9392-33
OPERATING INSTRUCTIONS
DOUBLE SHEET DETECTOR R1000 UDK20
1
A
38
65,5
A-A ( 1 : 2 )
20
2
A
3
enclosed = swingable angular connection
for hose: innerØ 6; outerØ 8
: unloaded 128±1
1
: unloaded 90±1
2
: Spring travel: appr. 37
3
Picture: Sensor holder SHS42G-FB
B0048991
110
50
Advertisement
Table of Contents
