Table of Contents
Advertisement
R O L A N D
Page 104
10.5 RPP-XP software (WinXP version)
Note: These brief instructions are valid only for the RPP XP-software.
The RPP XP- software is usable for the purpose of making a backup (safety copy) of the control unit
configuration and systems parameters. In case of a defective control unit for example these backup
parameter information can be transferred to another control unit
Hardware requirements
-
C-version of a ROLAND unit series R1000, such as E10, E20, I10, UDK10, UDK20 or
Fieldbus units
-
PC with Windows® 95/98/2000/NT/XP installed and a free serial interface or USB,
set at COM1 .. COM7
-
null modem cable for the serial interface, or USB-serial adapter
Installing the software
Place the supplied CD (No. 1) or floppy disc in the respective drive.
In order to start the set-up program proceed as follows (this example assumes that the
CD drive is „D"):
Windows button „Start" > „Execute"
1.
2.
Enter: „D:\setup.exe" (the character depends on your system configuration)
3.
Confirm with „OK"
4.
Then follow the instructions on the screen.
On installing, an entry „RPP-XP" in the Start menü „Programs" will be genereated.
Connection PC to R1000
The ROLAND control unit and the PC must be connected via the nullmodem cable (part of the
delivered contents) or a USB-serial adapter cable.
The ROLAND control unit must be switched to the Back-up mode.
Measures at the device:
- press MENUE key
- with arrow keys: change configuration
- press ENTER key
- with arrow keys: select Parameter Back-up
- press ENTER key again
The unit signals „Parameter Back-up active".
Starting the software
After successful installation the software can be executed as follows:
Windows button „Start" > „Programs" > „RPP_XP"
ROLAND ELECTRONIC GMBH · Otto-Maurer-Str. 17 · D-75210 Keltern · Telefon (0049) (07236) 9392-0 · Telefax (0049) (07236) 9392-33
OPERATING INSTRUCTIONS
DOUBLE SHEET DETECTOR R1000 UDK20
B0048991
Advertisement
Table of Contents
