Table of Contents
Advertisement
R O L A N D
Page 74
7.2 Operation
Note: The system is factory adjusted for "external single measurement". Therefore
the system functions only if the signal "measurement start" is activated. The
modification of the configuration is described in the following sections.
After applying power the type of the system, the version number and the bus system message are briefly
displayed. Afterwards the system switches into the measurement menu, which was active before the unit
was switched off.
1-1
FE=1.00
80% <S1=1.02> 120%
Functions of the keys (symbols below the keys)
↑
:
Change the parameters (forward)
↓
:
Change the parameters (backwards)
Enter
:
Selection of a parameter for the change and confirmation of the change
Menü
:
Activation of the menu level, for deleting a fault message and leave the menu level.
Functions of the LEDs (symbols above the keys)
<
:
ON, if the measured value equals or is below the lower limit value TU or falls below.
Norm
:
ON, if the measured value within the limits TU and TO lies.
>
:
ON, if the measured value reaches or exceeds the upper limit value TO.
Enable
:
- blinks, if a fault occurred
- ON, if the equipment is in the measurement mode
- OFF, during parameter programming with the keyboard
ROLAND ELECTRONIC GMBH · Otto-Maurer-Str. 17 · D-75210 Keltern · Telefon (0049) (07236) 9392-0 · Telefax (0049) (07236) 9392-33
OPERATING INSTRUCTIONS
DOUBLE SHEET DETECTOR R1000 UDK20
-ON
Picture: Frontal view of the R1000 with increased display cutout
1-1
FE=1.00
-ON
80% <S1=1.02> 120%
LED keys
B0048991
Program number
Selected sensor (1-4)
Material
Nominal thickness
Measurement active
Upper limit
Measuring value
Sensor no.
Lower limit
Advertisement
Table of Contents
