System Parameters - Roland udk20 Manual

Start-up
7.7

System parameters

The general adjustments are specified in the system parameters. For accessing, select the "system
parameter configuration" mode and confirm with ENTER.
System parameter 1: Setting the dialogue language.
system param.
language:english
Fig. 50: Selecting the dialogue language
System parameter 2: Specifying the type of sensor.
system param.
sensor type:PW42
Fig. 51: Specifying the type of sensor
Currently only the type of sensor PW42A is selectable.
System parameter 3: Specifying the number of connected sensors.
system param.
number sensors:2
Fig. 52: Specifying the number of sensors
Possible choices:
• for 2PW-unit: 1 / 2 sensors
• for SSB: 1 / 2 / 3 / 4 sensors
90
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000 series UDK20
Note
The selected system configuration should be documented in the form
"System configuration" in the chapter 13.2. This information is required in
case a system needs to be exchanged.
1
2
3
Attention
If a particular configuration is changed, all stored program
parameters are deleted. Then for all types of material the nominal
thicknesses must be entered again and the Teach-In executed.
Manual
B0048991 / Rev. 1.3