Spring Loaded Sensor Bracket Shs42G-Fb (With Bellow Suction Cup) - Roland R1000 Series Manual

Mounting
4.3.5

Spring loaded sensor bracket SHS42G-FB (with bellow suction cup)

The spring loaded sensor bracket SHS42G-FB with bellow suction cup is intended for the
installation of the P sensor. It is well suitable for use in robotic destackers, since transversal forces
(appearing on fast turning motions) are well compensated.
The suction vacuum and the integrated nap ring assure a full-area pressure contact of sensor and
sheet.
The suction cup has a Shore hardness of 45 (red), harder suction cups with a Shore hardness of
60 (black) are available (see chapter 12 „Order data - sensors and accessories).
On installing, attention must be paid that the sensor is thoroughly sealed (e.g. with Teflon tape) in
the thread seating.
Considerations:
• The sensor face must align with the naps.
•
The vacuum must adequately effect.
•
The suction facility must be kept free from loading, i.e. the springs may only be low pre-
tensioned.
•
The suction facility must not be used as load-lifting device.
60,5
39,5
Abb. 27: Sensor bracket SHS42G-FB
Pos : 34 /D oppel blech/Sensor en/Sens or halterungen/Klemmvorrichtung SH K @ 1\mod_1215005517687_501.doc @ 6429 @ 3 @ 1
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
58
Double Sheet Detector R1000 series E20
38
65,5
A-A
20
Manual
15
Beiliegend:
Schwenkbarer Winkelanschluß
für Schlauch
innen Ø6 mm, aussen Ø8 mm
: unbelastet 128±1
1
: unbelastet 90±1
2
: Federweg: ca. 37
3
B0046991 / Rev. 1.6
110
50