Cable (Fx -4Ad; Cable (Fx 3Uc -4Ad - Mitsubishi FX3U-4AD User Manual

FX /FX /FX PLC User's Manual - Analog Control Edition
3G 3U 3UC
FX -4AD/FX -4AD (4-channel Analog Input)
3U 3UC
3.2.3 Cable (FX
3UC
Use the following cables to connect with counterpart equipment. Terminate the cable end as shown below.
1. Cable
Applicable cable and tightening torque
0.3mm
Single wire
(AWG22 to 20)
Double wire
0.3mm
0.3mm
Rod terminal
(AWG22 to 20)
with
(Refer to the external
insulation
view of rod terminal
sleeve
shown in the following
figure.)
2. Termination of cable end
To terminate the cable, treat the stranded/single-wire directly or use the rod terminal with insulation sleeve.
• To directly terminate end of stranded/single-wire cable:
- Terminate the end of the stranded cable so that the "barbed wires"
cannot protrude.
- Do not solder-plate the end of the cable.
• To terminate cable end using rod terminal with insulation sleeve:
If the cable sheath is too thick, it may be difficult to insert the cable
into the insulation sleeve. For this reason, select an appropriate cable
while referring to the external view.
Manufacturer
Phoenix Contact
3. Tool
• To tighten terminals, use a purchased small-sized screwdriver whose head is straight and is not widened
as shown in the right figure.
Note:
If the diameter of screwdriver grip is too small, tightening torque will not
be able to be achieved. Use the following recommended screwdriver or
an appropriate replacement (grip diameter: approximately 25mm).
Manufacturer
Phoenix Contact
B-14
-4AD)
Wire size (stranded/ Tightening
single-wire)
2 2
to 0.5mm
2
(AWG22)
0.22N
2 2
to 0.5mm
Model
AI 0.5-8WH
torque
• To connect a stranded cable, peel the cover off the cable
and then twist the core before connection.
• To connect a single-wire cable, peel the cover off the
cable before connection.
• m to
• Rod terminal with insulation sleeve
0.25N m
•
(recommended terminal)
AI 0.5-8WH : Manufactured by Phoenix Contact
• Caulking tool
CRIMPFOX ZA 3 : Manufactured by Phoenix Contact
(or CRIMPFOX UD 6 : Manufactured by Phoenix Contact)
Caulking tool
CRIMPFOX ZA 3
(or CRIMPFOX UD 6)
Model
SZS 0.4×2.5
3.2 Cable and Terminal Tightening Torque
Termination
Termination of cable end
9mm
(0.35")
Insulation sleeve
Contact area
(Crimp area)
8mm
2.6mm
14mm
(0.1")
(0.55")
The head
should be
straight.
0.4mm 2.5mm
(0.09")
(0.01")
3 Wiring
(0.31")