Setting The Replay Parameter - Alcatel-Lucent 7450 System Management Manual

Setting the Replay Parameter

For this example the replay parameter was set by a SNMP SET request for the trap-target address
10.10.10.3 which is bound to port-id 1/1/1.
A:SetupCLI>config>log>snmp-trap-group 44
A:SetupCLI>config>log>snmp-trap-group# info
----------------------------------------------
replay
----------------------------------------------
A:SetupCLI>config>log>snmp-trap-group#
In the following output, note that the Replay field changed from disabled to enabled.
A:SetupCLI>config>log>snmp-trap-group# show log snmp-trap-group 44
===============================================================================
SNMP Trap Group 44
===============================================================================
Description : none
-------------------------------------------------------------------------------
Name
Address
Port
Version
Community
Sec. Level
Replay
Replay from : n/a
Last replay : never
-------------------------------------------------------------------------------
Name
Address
Port
Version
Community
Sec. Level
Replay
Replay from : n/a
Last replay : never
===============================================================================
A:SetupCLI>config>log>snmp-trap-group#
7450 ESS System Mangement Guide
trap-target "xyz-test" address 10.10.10.3 snmpv2c notify-community "xyztesting"
trap-target "test2" address 20.20.20.5 snmpv2c notify-community "xyztesting"
: xyz-test
: 10.10.10.3
: 162
: v2c
: xyztesting
: none
: enabled
: test2
: 20.20.20.5
: 162
: v2c
: xyztesting
: none
: disabled
Event and Accounting Logs
Page 431