Alcatel-Lucent 7450 System Management Manual page 222

Distributed CPU Protection Commands
Distributed CPU Protection Commands
dist-cpu-protection
Syntax dist-cpu-protection
Context config>system>security
Description This command enters the CLI context for configuration of the Distributed CPU Protection (DCP) fea-
ture.
policy
Syntax [no] policy policy-name
Context config>system>security>dist-cpu-protection
Description This command configures one of the maximum 16 Distributed CPU Protection policies. These poli-
cies can be applied to objects such as SAPs and network interfaces.
Parameters policy-name — Name of the policy to be configured.
description
Syntax [no] description string
Context config>system>security>dist-cpu-protection>policy
rate
Syntax rate kbps kilobits-per-second|max [mbs size] [bytes|kilobytes]
rate packets {ppi|max} within seconds [initial-delay packets]
no rate
Context config>system>security>dist-cpu-protection>policy>static-policer
config>system>security>dist-cpu-protection>policy>local-monitoring-policer
config>system>security>dist-cpu-protection>policy>protocol>dynamic-parameters
Description This command configures the rate and burst tolerance for the policer in either a packet rate or a bit
rate.
The actual hardware may not be able to perfectly rate limit to the exact configured parameters. In
this case, the configured parameters will be adapted to the closest supported rate. The actual (opera-
tional) parameters can be seen in CLI, for example, "show service id 33 sap 1/1/3:33 dist-cpu-protec-
tion detail".
Page 222 7450 ESS System Mangement Guide