Alcatel-Lucent 7450 System Management Manual page 482

Ethernet service switch

Hide thumbs Also See for 7450:

Table of Contents

Event Trigger Commands

entry-id — Specifies the identifier of the EHS event trigger entry.

event-handler

event-handler event-handler

no event-handler

config>log>event-trigger>event>trigger-entry

This command configures the event handler to be used for this trigger entry.

event-handler — Specifies the name of the event handler. Can be up to 32 characters maximum.

log-filter filter-id

no log-filter

config>log>event-trigger>event>trigger-entry

This command configures the log filter to be used for this trigger entry. The log filter defines the

matching criteria that must be met in order for the log event to trigger the handler execution. The log

filter is applied to the log event and, if the filtering decision results in a 'forward' action, then the

handler is triggered.

It is typically unnecessary to configure match criteria for 'application' or 'number' in the log filter

used for EHS since the particular filter is only applied for a specific log event application and

number, as configured under config>log>event-trigger.

filter-id — Specifies the identifier of the filter.

7450 ESS System Mangement Guide