Alcatel-Lucent 7450 System Management Manual page 483

Syslog Commands
syslog
Syntax [no] syslog syslog-id
Context config>log
Description This command creates the context to configure a syslog target host that is capable of receiving
selected syslog messages from this network element.
A valid syslog-id must have the target syslog host address configured.
A maximum of 10 syslog-id's can be configured.
No log events are sent to a syslog target address until the syslog-id has been configured as the log
destination (to) in the log-id node.
The syslog ID configured in the configure/service/vprn context has a local VPRN scope and only
needs to be unique within the specific VPRN instance. The same ID can be reused under a different
VPRN service or in the global log context under config>log.
Default No syslog IDs are defined.
Parameters syslog-id — The syslog ID number for the syslog destination, expressed as a decimal integer.
address
Syntax address ip-address
no address
Context config>log>syslog syslog-id
Description
This command adds the syslog target host IP address to/from a syslog ID.
This parameter is mandatory. If no address is configured, syslog data cannot be forwarded to the
syslog target host.
Only one address can be associated with a syslog-id. If multiple addresses are entered, the last address
entered overwrites the previous address.
The same syslog target host can be used by multiple log IDs.
The no form of the command removes the syslog target host IP address.
Default no address — There is no syslog target host IP address defined for the syslog ID.
Parameters
ip-address — The IP address of the syslog target host in dotted decimal notation.
7450 ESS System Mangement Guide
Values 1 — 10
Event and Accounting Logs
Page 483