Alcatel-Lucent 7450 System Management Manual page 251

Table 18: Show Distributed CPU Protection Policer Output Fields (Continued)
Sample Output
*A:Dut-A# show router interface "test" dist-cpu-protection detail
===============================================================================
Interface "test" (Router: Base)
===============================================================================
Distributed CPU Protection Policy :
-------------------------------------------------------------------------------
Statistics/Policer-State Information
7450 ESS System Mangement Guide
Label
Exceed-Count
Detec. Time Remain
Hold-Down Remain
All Dyn-Plcr Alloc.
Dyn-Policer Alloc.
Oper. Kbps - The adapted 'kilobits-per-second' value for DCP 'kbps'
rates
Oper. MBS - The adapted 'mbs size' value for DCP 'kbps' rates
Oper. Depth - The calculated policer bucket depth in packets (for
DCP 'packets' rates) or in bytes (for DCP 'kbps'rates)
Oper. Packets - The adapted 'ppi' value for DCP 'packets' rates
Oper. Within - The adapted 'within seconds' value for DCP 'packets'
rates
Oper. Init. Delay - The adapted 'initial-delay packets' value for DCP
'packets' rates
The count of packets exceeding the policing parameters since the
given policer was previously declared as conformant or newly
instantiated. This counter has the same behavior as the exceed
counter in the DCP the log events – they are baselined (reset) when
the policer transitions to conformant.
The remaining time in the detection-time countdown during which a
policer in the exceed state is being monitored to see if it is once again
conformant.
The remaining time in the hold-down countdown during which a
policer is treating all packets as exceeding.
Indicates that all the dynamic enforcement policers have been allo-
cated and instantiated for a given local-monitor.
Indicates that a dynamic policer has been instantiated.
dcpuPol
Description
Page 251
Security