Table 52: Snmp Trap Group Output Fields - Alcatel-Lucent 7450 System Management Manual

snmp-trap-group
Syntax snmp-trap-group [log-id]
Context show>log
Description This command displays SNMP trap group configuration information.
Parameters
log-id — Displays only SNMP trap group information for the specified trap group log ID.
Output SNMP Trap Group Output — The following table describes SNMP trap group output fields.
Sample Output
A:SetupCLI>config>log>snmp-trap-group# show log snmp-trap-group 44
===============================================================================
SNMP Trap Group 44
===============================================================================
Description : none
-------------------------------------------------------------------------------
Name
Address
Port
7450 ESS System Mangement Guide
Values 1 — 99

Table 52: SNMP Trap Group Output Fields

Label
Log-ID
Address
Port
Version
Community
Security-Level
Replay
Replay from
Last Replay
: ntt-test
: 10.10.10.3
: 162
The log destination ID for an event stream.
The IP address of the trap receiver,
The destination UDP port used for sending traps to the destination,
expressed as a decimal integer.
Specifies the SNMP version format to use for traps sent to the trap
receiver. Valid values are snmpv1, snmpv2c, snmpv3.
The community string required by snmpv1 or snmpv2c trap receivers.
The required authentication and privacy levels required to access the
views on this node.
Indicates whether or not the replay parameter has been configured,
enabled or disabled, for the trap-target address.
Indicates the sequence ID of the first missed notification that will be
replayed when a route is added to the routing table by which trap-target
address can be reached. If no notifications are waiting to be replayed
this field shows n/a.
Indicates the last time missed events were replayed to the trap-target
address. If no events have ever been replayed this field shows never.
Event and Accounting Logs
Description
Page 541