Alcatel-Lucent 7450 System Management Manual page 217

Parameters packet-rate-limit — Specifies a packet arrival rate limit in packets per second.
log-events — issues a tmnxCpmProtViolSapOutProf, tmnxCpmProtViolIfOutProf, or
overall-rate
Syntax overall-rate packet-rate-limit
no overall-rate
Context config>sys>security>cpu-protection>policy
Description This command applies a maximum packet arrival rate limit (applied per SAP/interface) for the entire
SAP/interface, above which packets will be discarded immediately. The rate defined is a global rate
limit for the interface regardless of how many traffic flows are present on the SAP/interface. It is a
per-SAP/interface rate.
The no form of the command sets overall-rate parameter back to the default value.
Default
max for cpu-protection-policy-id 1 — 253
6000 for cpu-protection-policy-id 254 (default access interface policy)
max for cpu-protection-policy-id 255 (default network interface policy)
Parameters packet-rate-limit — Specifies a packet arrival rate limit in packets per second.
per-source-rate
Syntax per-source-rate packet-rate-limit
no per-source-rate
Context config>sys>security>cpu-protection>policy
Description This command configures a per-source packet arrival rate limit. Use this command to apply a packet
arrival rate limit on a per source basis. A source is defined as a unique combination of SAP and MAC
source address (mac-monitoring) or SAP and source IP address (ip-src-monitoring). The CPU will
receive no more than the configured packet rate from each source (only certain protocols are rate lim-
ited for ip-src-monitoring as configured under 'include-protocols' in the cpu protection policy). The
measurement is cleared each second.
This parameter is only applicable if the policy is assigned to an interface (some examples include
saps, subscriber-interfaces, and spoke-sdps), and the mac-monitor or ip-src-monitor keyword is
specified in the cpu-protection configuration of that interface.
The ip-src-monitoring is useful in subscriber management architectures that have routers between the
subscriber and the BNG (router). In layer-3 aggregation scenarios, all packets from all subscribers
7450 ESS System Mangement Guide
Values 1 — 65535, max (max indicates no limit)
tmnxCpmProtViolSdpBindOutProf log event and tracks violating interfaces when the out-
profile-rate is exceeded. Supported on CPM3 and above only.
Values
1 — 65535, max (max indicates no limit)
Security
Page 217