Alcatel-Lucent 7450 System Management Manual page 491

filter
Syntax filter filter-id
no filter
Context config>log>log-id log-id
Description This command adds an event filter policy with the log destination.
The filter command is optional. If no event filter is configured, all events, alarms and traps generated
by the source stream will be forwarded to the destination.
An event filter policy defines (limits) the events that are forwarded to the destination configured in
the log-id. The event filter policy can also be used to select the alarms and traps to be forwarded to a
destination snmp-trap-group.
The application of filters for debug messages is limited to application and subject only.
Accounting records cannot be filtered using the filter command.
Only one filter-id can be configured per log destination.
The no form of the command removes the specified event filter from the log-id.
Default no filter — No event filter policy is specified for a log-id.
Parameters filter-id. The event filter policy ID is used to associate the filter with the log-id configuration. The
from
Syntax from {[main] [security] [change] [debug-trace]}
no from
Context config>log>log-id log-id
Description This command selects the source stream to be sent to a log destination.
One or more source streams must be specified. The source of the data stream must be identified using
the from command before you can configure the destination using the to command. The from
command can identify multiple source streams in a single statement (for example: from main change
debug-trace).
Only one from command may be entered for a single log-id. If multiple from commands are
configured, then the last command entered overwrites the previous from command.
The no form of the command removes all previously configured source streams.
Default No source stream is configured.
Parameters main — Instructs all events in the main event stream to be sent to the destination defined in the to
7450 ESS System Mangement Guide
event filter policy ID must already be defined in config>log>filter filter-id.
Values 1 — 1000
command for this destination log-id. The main event stream contains the events that are not
explicitly directed to any other event stream. To limit the events forwarded to the destination,
configure filters using the filter command.
Event and Accounting Logs
Page 491