Alcatel-Lucent 7450 System Management Manual page 486

Syslog Commands
Only a single threshold level can be specified. If multiple levels are entered, the last level entered will
overwrite the previously entered commands.
The no form of the command reverts to the default value.
Parameters value — The threshold severity level name.
port
Syntax port value
no port
Context config>log>syslog syslog-id
Description
This command configures the UDP port that will be used to send syslog messages to the syslog target
host.
The port configuration is needed if the syslog target host uses a port other than the standard UDP
syslog port 514.
Only one port can be configured. If multiple port commands are entered, the last entered port
overwrites the previously entered ports.
The no form of the command reverts to default value.
Default no port
Parameters
value — The value is the configured UDP port number used when sending syslog messages.
Page 486
Values emergency, alert, critical, error, warning, notice, info, debug
Router Numerical Severity
severity level (highest to lowest)
3
4
5
6
1 cleared
2 indeterminate
Values 1 — 65535
Configured
Severity
0 emergency
1 alert
2 critical
3 error
4 warning
5 notice
6 info
7 debug
7450 ESS System Mangement Guide
Definition
system is unusable
action must be taken immedi-
ately
critical condition
error condition
warning condition
normal but significant condition
informational messages
debug-level messages