Alcatel-Lucent 7450 System Management Manual page 495

The to command cannot be modified or re-entered. If the destination or maximum size of an SNMP
or memory log needs to be modified, the log ID must be removed and then re-created.
Default none
Parameters size — The size parameter defines the number of events stored in this memory log.
to syslog
Syntax to syslog syslog-id
Context config>log>log-id
Description This is one of the commands used to specify the log ID destination. This parameter is mandatory
when configuring a log destination.
This command instructs the alarms and traps to be directed to a specified syslog. To remain consistent
with the standards governing syslog, messages to syslog are truncated to 1k bytes.
The source of the data stream must be specified in the from command prior to configuring the
destination with the to command.
The to command cannot be modified or re-entered. If the destination or maximum size of an SNMP
or memory log needs to be modified, the log ID must be removed and then re-created.
Default none
Parameters syslog-id — Instructs the events selected for the log ID to be directed to the syslog-id. The character-
time-format
Syntax time-format {local | utc}
Context config>log>log-id
Description This command specifies whether the time should be displayed in local or Coordinated Universal Time
(UTC) format.
Default utc
Parameters
local — Specifies that timestamps are written in the system's local time.
utc — Specifies that timestamps are written using the UTC value. This was formerly called
7450 ESS System Mangement Guide
Default 100
Values
50 — 1024
istics of the syslog-id referenced here must have been defined in the config>log>syslog syslog-id
context.
Values 1 — 10
Greenwich Mean Time (GMT) and Zulu time.
Event and Accounting Logs
Page 495