Ip Interface Commands - D-Link DES-3226L Reference Manual

DES-3226L Layer 2 Fast Ethernet Switch User's Guide
The IP interface commands in the Command Line Interface (CLI)
are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config ipif System [vlan <vlan_name> | ipaddress
<network_address> | state
[enabled|disabled]]
bootp dhcp
show ipif <ipif_name>
Each command is listed, in detail, in the following sections.
config ipif System
Purpose Used to configure the System IP interface.
Syntax config ipif System [{vlan
<vlan_name>|ipaddress
<network_address>|state
[enabled|disabled]|bootp|dhcp}]
Description This command is used to configure the
System IP interface on the switch
17
IP I
NTERFACE
C
OMMANDS
162