D-Link DES-3226L Reference Manual page 130

DES-3226L Layer 2 Fast Ethernet Switch User's Guide
config bandwidth_control
Purpose Used to configure bandwidth control on a
by-port basis.
Syntax config bandwidth_control <portlist>
{rx_rate [no_limit|<value 1-
1000>]|tx_rate [no_limit|<value 1-
1000>]}
Description The config bandwidth_control command
is used to configure bandwidth on a by-
port basis.
<portlist> − Specifies a range of ports to be
Parameters
configured. The port list is specified by
listing the lowest switch number and the
beginning port number on that switch,
separated by a colon. Then the highest
switch number, and the highest port
number of the range (also separated by a
colon) are specified. The beginning and end
of the port list range are separated by a
dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch
number 2, port 4. 1:3-2:4 specifies all of
the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order.
rx_rate − Specifies that one of the
parameters below (no_limit or <value 1-
1000>) will be applied to the rate at which
the above specified ports will be allowed to
receive packets
no_limit − Specifies that there will be no
limit on the rate of packets received by the
130