D-Link DES-3226L Reference Manual page 104

DES-3226L Layer 2 Fast Ethernet Switch User's Guide
config syslog host
will be sent to the remote host. This
corresponds to number 20 from the list above.
local5 − Specifies that local use 5 messages
will be sent to the remote host. This
corresponds to number 21 from the list above.
local6 − Specifies that local use 6 messages
will be sent to the remote host. This
corresponds to number 22 from the list above.
local7 − Specifies that local use 7 messages
will be sent to the remote host. This
corresponds to number 23 from the list above.
udp_port <int> − Specifies the UDP port
number that the syslog protocol will use to
send messages to the remote host.
ipaddress <ipaddr> − Specifies the IP address
of the remote host where syslog messages will
be sent.
state [enabled|disabled] − Allows the sending
of syslog messages to the remote host,
specified above, to be enabled and disabled.
Restrictions Only administrator-level users can issue this
command.
Example usage:
To configure a syslog host:
104