D-Link DES-3226L Reference Manual page 131

DES-3226L Layer 2 Fast Ethernet Switch User's Guide
config bandwidth_control
above specified ports.
<value 1-1000> − Specifies the packet limit,
in Mbps, that the above ports will be
allowed to receive.
tx_rate − Specifies that one of the
parameters below (no_limit or <value 1-
1000>) will be applied to the rate at which
the above specified ports will be allowed to
transmit packets.
no_limit − Specifies that there will be no
limit on the rate of packets received by the
above specified ports.
<value 1-1000> − Specifies the packet limit,
in Mbps, that the above ports will be
allowed to receive. Gigabit ports must be
configured to using a limit value that is a
multiple of 8 i.e. for Gigabit ports <value 8-
1000 in increments of 8>.
Restrictions Only administrator-level users can issue
this command.
Example usage:
To configure bandwidth control:
131