D-Link DES-3226L Reference Manual page 84

DES-3226L Layer 2 Fast Ethernet Switch User's Guide
Command Parameters
create syslog config syslog host [all|<index 1-4>] {severity
host [informational|warning|all]|
facility[local0|local1|local2|local3|
local4|local5|local6|local7]|udp_port<int>|
ipaddress <ipaddr>| state[enable|disable]
delete syslog [<index 1-4> |all]
host
show syslog [index 1-4>]
host
Each command is listed, in detail, in the following sections.
show packet ports
Purpose Used to display statistics about the packets
sent and received by the switch.
Syntax show packet ports <portlist>
Description This command is used to display statistics
about packets sent and received by ports
specified in the port list.
<portlist> − specifies a range of ports to be
Parameters
configured. The port list is specified by
listing the beginning port number and the
highest port number of the range. The
beginning and end of the port list range are
separated by a dash. For example, 3 would
specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and
port 4 − in numerical order.
Restrictions none.
84