D-Link DES-3226L Reference Manual page 149

DES-3226L Layer 2 Fast Ethernet Switch User's Guide
config gvrp
and the GVRP status for each port.
Parameters <portlist> − A range of ports for which you
want ingress checking. The port list is
specified by listing the beginning port
number and the highest port number of the
range. The beginning and end of the port
list range are separated by a dash. For
example, 3 would specify port 3. 4 specifies
port 4. 3-4 specifies all of the ports
between port 3 and port 4 − in numerical
order.
all −
switch.
state
disables GVRP for the ports specified in the
port list.
ingress_checking
Enables or disables ingress checking for
the specified port list.
Restrictions Only administrator-level users can issue
this command.
Example Usage:
To sets the ingress checking status and the GVRP
status:
DES-3226L:4#config gvrp 1-5 state enable
ingress_checking enable
Command: config gvrp 1-5 state enable
ingress_checking enable
Specifies all of the ports on the
−
[enabled|disabled]
[enabled|disabled]
149
Enables or
−