D-Link DES-3226L Reference Manual page 189

DES-3226L Layer 2 Fast Ethernet Switch User's Guide
config 802.1x auth_parameter
[force_unauth|auto|force_auth]|
quiet_period <sec 0-65535>| max_req
<value
65535>|enable_reauth
[enabled|disabled]}]
Description
The
command is used to configure the 802.1x
Authentication parameters on a range of
ports. The default parameter will return all
ports in the specified range to their default
802.1x settings.
Parameters
<portlist> − Specifies a range of ports. The
port list is specified by listing the beginning
port number and the highest port number
of the range. The beginning and end of the
port list range are separated by a dash. For
example, 3 would specify port 3. 4 specifies
port 4. 3-4 specifies all of the ports
between port 3 and port 4 − in numerical
order.
all − Specifies all of the ports on the switch.
default − Returns all of the ports in the
specified range to their 802.1x default
settings.
direction [both|in] − Determines whether a
controlled port blocks communication in
both
directions, or just the receiving direction.
port_control
1-10>|reauth_period
config 802.1x auth_parameter
the receiving and
−
Configures
189
<sec 1-
transmitting
the