D-Link DES-3226L Reference Manual page 8

DES-3226L Layer 2 Fast Ethernet Switch User's Guide
1. Starting at the command line prompt DES-3226L:4#
− enter the commands config ipif System ipaddress
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy. Where the x's
represent the IP address to be assigned to the IP
interface named System and the y's represent the
corresponding subnet mask.
2. Alternaltively, you can enter DES-3226L:4# − enter
the commands
xxx.xxx.xxx.xxx/z. Where the x's represent the IP
address to be assigned to the IP interface named
System and the z represents the corresponding
number of subnets in CIDR notation.
The IP interface named System on the switch can be assigned
an IP address and subnet mask which can then be used to
connect a management station to the switch's Telnet or Web-
based management agent.
Figure 1-3. Assigning the Switch an IP Address
config ipif System
8
ipaddress