D-Link DES-3226L Reference Manual page 42

DES-3226L Layer 2 Fast Ethernet Switch User's Guide
config ports
[auto|10_half|10_full|100_half|100_full|
1000_full]
flow_control [enabled|disabled]
learning [enabled|disabled]
state [enabled|disabled]}
Description This command allows for the configuration of
the switch's Ethernet ports. Only the ports
listed in the <portlist> will be effected.
Parameters all − Displays all ports on the switch.
portlist − Specifies a range of ports to be
configured. The port list is specified by listing
the beginning port number and the highest
port number of the range. The beginning and
end of the port list range are separated by a
dash. For example, 3 would specify port 3. 4
specifies port 4. 3-4 specifies all of the ports
between port 3 and port 4 − in numerical
order.
−
auto
specified range of ports.
[10|100|1000] − Configures the speed in Mbps
for the specified range of ports. Gigabit ports
are statically set to 1000 and cannot be set to
slower speeds.
[half|full] − Configures the specified range of
ports as either full- or half-duplex.
Enables auto-negotiation
42
for the