4.1.3.14 Drive Shaft E (Eject) and Eject Roller
(1)
Disassembly procedure
a)
First, carry out procedure up to the point
of the 4.1.3.2 (ID Unit, Cover-Rear, Cover-
NCU and Cover-MAIN).
Remove two screws 1 from Cover Heat
b)
Assembly (section 4.3.7), lift the heat
assay, and dismount idle gear E (A) and
idle gear E (B).
c)
Unlock and dismount drive shaft E (Eject).
d)
Dismount two eject rolles.
(2)
Reassembly procedure
Reverse the disassembly procedures.
40055101TH Rev.4
Drive shaft E (Eject)
Eject roller
Screw 1
Idle gear E (B)
Idle gear E (A)
(CP4.1 Fig. 29)
175 /