Tqsb-2Pcb; Hopping Roller Shaft Assy And One-Way Clutch Gear - Oki OKIFAX 5400 Maintenance Manual

3.3.2 TQSB2-PCB
(1) Remove the pulse motor (see 3.3.1).
Remove the connector O from the TQSB-2PCB P.
(2)
(3) Remove the screw Q and remove the TQSB-2PCB P.
Note : Refer to Detall A in the previous page.
3.3.3

Hopping Roller Shaft Assy and One-way Clutch Gear

(1) Follow up to step (3) of 3.3.1 and remove the hopping frame assy.
(2) Remove the screw 1 and remove the earth plate 2. Remove the sensor lever 7 and remove
the ground plate 6. Remove the gear 3 and remove the metal bush 5 and Hopping Roller shaft
Assy 4.
Remove the E-ring A and remove the one-way clutch gear B on the right side of the feed roller
(3)
0.
Note : The metal bush C also comes off. Be careful not to lose it.
8
40838301TH Rev.1
4Hopping Roller Shaft Assy
1
2
9
5
6
F - 9
3
A
7
C
0
B