Separation Rubber, Roller Assembly Sensor - Oki B 4100 Maintenance Manual

4.1.3.4 Separation Rubber, Roller Assembly Sensor

(1) Disassembly procedure
a) Separation rubber:
The separation rubber can be removed
from the Frame Assembly-Scanner (U).
b) Roller Assembly Sensor:
Remove the Plate-Support by removing
the two screws 1.
Note: Just fitting to two bossess.
c) Remove the two springs (L) and (R).
d) Remove the Roller Assembly-Sensor by
removing the Gear (Z31).
(2) Reassembly procedure
Reverse the disassembly procedure.
40055101TH Rev.4
Frame Assembly-Scanner (U)
Spring (L) Spring (R)
Roller Assembly Sensor
Earth Cable
(CP4.1 Fig. 15)
Gear (Z31)
Bearing S
Plate-Support
(CP4.1 Fig. 16)
163 /