Oki B 4100 Maintenance Manual page 608

Remove three screws 9 which are holding the guide R (2nd) assy 0 to the bottom plate A. Remove
(6)
the screw B which is keeping the rear cover C and guide R (2nd) assy 0. Remove the guide R (2nd)
assy 0.
Remove the protect (M) D, guide bracket E, planet gears F and planet gear bracket G.
(7)
Remove the E-ring H which is keeping the sheet link I on the guide R (2nd) assy 0, and pull out the
(8)
hinge stand J.
Remove three remaining screws K which are keeping the motor on the motor bracket L, and remove
(9)
the connector off the Stepping Motor M.
(10) Remove two screws N on the Stepping Motor M.
J
K
Rear Cover C
40055101TH Rev.4
I
O
Q
D
Motor Bracket L
Detail A
O
TQSB-2PCB P
E
G
F
B
9
A
Guide R (2nd) Assy 0
H
N
M
Motor
608 /