Oki B 4100 Maintenance Manual page 536

B2.3.2.3 Paper Feed Monitoring
Status
Paper supply error
Transport system jam 1
Transport system jam 2
Transport system jam 3
Paper size error
Paper outlet jam 1
Paper outlet jam 2
B2.3.2.4 2'nd Tray Communication Error
This error is generated if on sending a command to the 2'nd tray is returned no-status (40s) or an unde-
fined status. However, in case there is no status when reset, it will be considered that the 2'nd tray is not
mounted.
B2.3.2.5 Cover Open
Cover open sensor "0" indicates an open cover.
When the cover is closed the CU (control unit) section sends the reset signal and processes in the same
way as if the power has been turned on.
40055101TH Rev.4
Description and Supervising Sensor
Indicates monitoring error in hopping.
Hopping is retried 3 times.
Indicates an error in the paper transport path.
Error on resist roller section.
From resist ON to write sensor (PS2) ON.
From inlet sensor OFF up to write sensor OFF.
Indicates an error in the paper transport system.
Error of transfer roller and/or heat roller.
From write sensor ON to outlet sensor ON.
Indicates paper size other than specified one.
From resist ON to inlet sensor OFF.
Supervises slipping of the recording paper.
From outlet sensor ON to OFF.
Supervises jamming at the near paper outlet.
From outlet sensor ON to OFF.
When a crumpled recording paper is detected, the outlet
sensor is set to "OFF" earlier than usual.
Distance
118 mm or less path
Length +36 (hopping) x 3
30 mm or less
Inlet ~ write +20
44 mm or less
207 mm or less
Write ~ outlet +69
Recording paper +/- 45 mm
Recording paper +/- 45 mm
135 mm or less: NG
536 /