Resetting A Port - Nortel 2300 Series Configuration Manual

Note.
PoE is supported only on 10/100 Ethernet ports. PoE is not supported on any
gigabit Ethernet ports, or on ports 7 and 8 on an WSS-2360 switch.
To change the PoE state on a port, use the following command:
set port poe port-list enable | disable

Resetting a Port

You can reset a port by toggling its link state and PoE state. WSS Software disables the port's link and PoE (if
applicable) for at least one second, then reenables them. This feature is useful for forcing an AP access point
that is connected to two WSS switches to reboot using the port connected to the other switch.
To reset a port, use the following command:
reset port port-list
Configuring and Managing Ports and VLANs 83
Nortel WLAN Security Switch 2300 Series Configuration Guide