Rf Auto-Tuning Parameters - Nortel 2300 Series Configuration Manual

RF Auto-Tuning Parameters

Table 19 lists the RF Auto-Tuning parameters and their default settings.
Table 19: Defaults for RF Auto-Tuning Parameters
Parameter
Radio profile parameters
channel-config
channel-interval
channel-holddown
power-config
power-interval
power-backoff-timer
Individual radio parameters
max-power
Default
Value
enable
3600
900
disable
300
10
Maximum
allowed for
country of
operation
Nortel WLAN Security Switch 2300 Series Configuration Guide
Configuring RF Auto-Tuning 295
Radio Behavior When
Parameter Set To Default
Value
When the radio is first enabled,
RF Auto-Tuning sets the channel based
on the channels in use on neighboring
access ports.
Every 3600 seconds, WSS Software
examines the RF information gathered
from the network and determines
whether the channel needs to be
changed to compensate for RF changes.
WSS Software maintains the channel
setting on a radio for at least 900
seconds regardless of RF changes.
WSS Software uses the highest power
level allowed for the country of
operation or the highest supported by
the hardware, whichever is lower.
Every 300 seconds, WSS Software
examines the RF information gathered
from the network and determines
whether the power needs to be changed
to compensate for RF changes.
If RF Auto-Tuning has increased power
due to unacceptably high packet
retransmissions or to maintain at least
the minimum data rate for clients, and
those conditions are no longer
occurring, the radio reduces power by
1 dBm every 10 seconds, so long as the
conditions do not recur.
RF Auto-Tuning never sets a radio's
power to a level that is higher than the
maximum allowed for the country of
operation (countrycode).