Disabling Or Reenabling All Radios Using A Profile - Nortel 2300 Series Configuration Manual

Disabling or Reenabling All Radios Using a Profile

To disable or reenable all radios that are using a radio profile, use the following command:
set radio-profile name [mode {enable | disable}]
The following command enables all radios that use radio profile rp1:
23x0# set radio-profile rp1 mode enable
success: change accepted.
The following commands disable all radios that use radio profile rp1, change the beacon interval, then
reenable the radios:
23x0# set radio-profile rp1 mode disable
success: change accepted.
23x0# set radio-profile rp1 beacon-interval 200
success: change accepted.
23x0# set radio-profile rp1 mode enable
success: change accepted.
Nortel WLAN Security Switch 2300 Series Configuration Guide
Configuring AP access points 279