Displaying Connection Information For Distributed Aps - Nortel 2300 Series Configuration Manual

Configuring AP access points 285

Displaying Connection Information for Distributed APs

A Distributed AP can have only one active data connection. To display the system IP address of the WSS that has the
active connection, use the following command:
show dap connection [dap-num | serial-id serial-ID]
The serial-id parameter displays the active connection for a Distributed AP even if that AP is not configured on this
WSS. However, if you use the command with the dap-num parameter or without a parameter, connection information is
displayed only for Distributed APs that are configured on this WSS.
Nortel WLAN Security Switch 2300 Series Configuration Guide